3dfx Archive - Voodoo 2 jinxed help

	Welcome, Guest. Please Login

Home

Help

3dfx Archive › General Section › General Discussion › Voodoo 2 jinxed help

(Moderators: FalconFly, gdonovan, NitroX infinity)

‹ Previous Topic | Next Topic ›

Pages: 1 2

Voodoo 2 jinxed help (Read 414 times)

procerus

Full Member

Offline

Voodoo2 Monomaniac

Posts: 189

Re: Voodoo 2 jinxed help
Reply #15 - 12.07.03 at 22:05:21

Gavin said:
Quote:

When I had the DirectX7 drivers installed (Latest official drivers) it did have a voodoo tab I think....
but it would lockup whenever I touched it... which was what made me believe ineeded the older directX6.1 drivers for a fresh install of Windows 98 SE

Go back to this configuration. Then go to Start, Run and type in "msconfig" (without the quotes). Uncheck the Voodoo2 reference under the Startup tab. Then reboot.

Now try to access the Voodoo2 tab in Display Properties. And see if there's a "Display 2" tab under DXDiag. Any better?

98lite with

629K

of free conventional memory in full DOS mode using QEMM 9.0 (or 628K with UMBPCI.SYS providing real mode for FastVid) with SmartDrive, CD-ROM, CuteMouse, sound support and UniRefresh all loaded high.

IP Logged

Gavin Greenwalt Guest	Re: Voodoo 2 jinxed help Reply #16 - 12.07.03 at 23:46:04 Thanks for the advice about using fastvoodoo 3.0 I found some forums on Google Groups about this... and I emailed the desperate brother abroad for hope and inspiration, hopefully someone has finally fixed it with the exact same problem. Hmmm a Voodoo 5 5500 is only 18 bucks.... that sounds mighty nice about now.
Back to top	IP Logged

Gavin Greenwalt Guest	Re: Voodoo 2 jinxed help Reply #17 - 13.07.03 at 00:18:14 There is no Voodoo 2 option under msconfig... should there? I installed DirectX 8.0 and Fast Voodoo 3.0 (which actually worked this time) and to no avail... still the same. I even jiggled the monitor cable... still didn't work.
Back to top	IP Logged

FalconFly YaBB Administrator Offline 3dfx Archivist Posts: 2445 5335N 00745E Gender:	Re: Voodoo 2 jinxed help Reply #18 - 13.07.03 at 01:31:39 Hmm... Well, unless your Card works fine in another System, I'd say it's either defective, or shows a rare incompatibility with your System (?) How hot does it get when in the System ?
Back to top	WebMaster FalconFly Central 3dfx Archive IP Logged

Pages: 1 2

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page