Case front view.
8164 with power board and shroud.
Someone at Quantum3D has a sense of humor eh?
Case overview before installing card, much re-routing of cables has been done!
One problem was the shroud would not fit with SCSI drive cable installed! The original AAlchemy GX systems did not have the shroud now used to duct air. As luck would have it I have a spare shroud so headed out to the garage to do some machining.
As installed in machine, perfect!
The two massive 120 mm fans used to keep things cool.
There is also a shroud that is suppose to be in this area for airflow control, I'll have it in the near future.
Card finally installed!
Rear view of installed card.
With top cover on you can see the foam attached to the lid that keeps the graphics board firmly in place.
The grill that is missing from the rear of the case should be here in the near future, with the grill out I was able to take the picture above. There was also a module that fit in this location that was an optional sensor unit.