Welcome, Guest. Please Login 3dfx Archive
 
 
  HomeHelpSearchLogin  
 
  3dfx Archive › General Section › General Discussion › Voodoo2 1000 question...
(Moderators: gdonovan, FalconFly, NitroX infinity)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1
Send Topic Print
Voodoo2 1000 question... (Read 75 times)
tiggere
YaBB Newbies
*
Offline


I love YaBB 1G - SP1!

Posts: 1
Voodoo2 1000 question...
21.03.07 at 18:17:36  
Hey guys...I have a Voodoo2 1000 based on the "Find your hardware" page...but mine has some slight differences...both plugs are blue and on the small chips it says "EliteMT"...other than that its the same...what are these going for...it has the cable that goes with it...original drivers and paperwork somewhere...just don't know where right now Smiley...this looks to be a pretty cool site...never knew there was this large a fan base for these graphic cards...

Oh...and weren't the V2's able to be used with another V2 card...by hooking them together?
Back to top
 
 
IP Logged
 
gamma742
God Member
*****
Offline


3Dfx Gamer

Posts: 1668
San Diego, CA  USA
Gender: male
Re: Voodoo2 1000 question...
Reply #1 - 21.03.07 at 18:27:14  
If you have the original box it has pretty good value here, otherwise you are better off selling it on ebay.

They did use different connectors and memory over the years EliteMT was one. Nothing to get excited about.

And yes you can connect two of these cards together via the connector on top of the card and run them what a known as "SLI" mode.
Back to top
 
Quantum3D AAlchemy 3 Channel SwapLock/SyncLock System.  Powered by VSA 100 GPUs Running in SLI Mode. 3dfx at it's Best......
gamma742 https://www.facebook.com/bob.waller  
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
‹ Previous Topic | Next Topic ›
  « Home ‹ Board Top of this page

3dfx Archive » Powered by YaBB 2.4!
YaBB © 2000-2009. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge