Hi everyone,

I fixed the Primary Image Barracuda from exxe and also build a small adapter for power supply.

The card can be seen in the device manager, but I need the drivers to further test the card. Does someone have these?

Here pictures of the card and my repair:

http://www.abload.de/thumb/before_1v8l3a.jpg http://www.abload.de/thumb/before_2ubzqk.jpg -> The Barracuda
http://www.abload.de/thumb/before_8s0aw2.jpg
http://www.abload.de/thumb/before_3lrx17.jpg http://www.abload.de/thumb/before_48tymv.jpg -> the card in detailed view
http://www.abload.de/thumb/before_92kycx.jpg http://www.abload.de/thumb/before_10rnz39.jpg
http://www.abload.de/thumb/before_5bilz1.jpg http://www.abload.de/thumb/before_6n8y0s.jpg -> The card does have an extra PCB for powersupply. It needs 5V and 6A connected to the 4pin connector on the rear.
http://www.abload.de/thumb/before_7jpxvq.jpg
http://www.abload.de/thumb/before_11col8u.jpg -> Quartz crystal on back is broken... It's a normal quartz with 14.318MHz

-----

http://www.abload.de/thumb/after_1asym6.jpg -> new quartz
http://www.abload.de/thumb/after_20nz4t.jpg -> Solderpads cleaned
http://www.abload.de/thumb/after_319lvq.jpg http://www.abload.de/thumb/after_4m7ze4.jpg http://www.abload.de/thumb/after_5u7xss.jpg -> new quartz soldered

-----

My selfmade molex adapter to provide the card with the needed powersupply.

http://www.abload.de/thumb/adapter_1c9odd.jpg http://www.abload.de/thumb/adapter_2l8rs7.jpg
http://www.abload.de/thumb/adapter_31ur9q.jpg -> The right two pins (yellow) are 5V and the black ones are ground.
http://www.abload.de/thumb/test_17crg9.jpg http://www.abload.de/thumb/test_2u1oyz.jpg -> The card shown under Everest Ultimate

So if anyone does have the drivers please share them :)

Regards,
Löschzwerg