3dfx Archive - [S] - 3dfx Voodoo5 5500 AGP 4x Protoype

	Welcome, Guest. Please Login

Home

Help

3dfx Archive › This & That › Marketplace › [S] - 3dfx Voodoo5 5500 AGP 4x Protoype

(Moderators: NitroX infinity, gdonovan, FalconFly)

‹ Previous Topic | Next Topic ›

Pages: 1

[S] - 3dfx Voodoo5 5500 AGP 4x Protoype (Read 439 times)

rottentreats God Member Offline 3dfx > Reality Posts: 616 Minnesota [USA] Gender:	[S] - 3dfx Voodoo5 5500 AGP 4x Protoype 22.07.13 at 02:42:14 Pictured like below. Sent me a PM for details/pricing.
Back to top	« Last Edit: 22.07.13 at 02:42:55 by rottentreats » IP Logged

rottentreats God Member Offline 3dfx > Reality Posts: 616 Minnesota [USA] Gender:	Re: [S] - 3dfx Voodoo5 5500 AGP 4x Protoype Reply #1 - 26.07.13 at 20:34:55 Bump, these are selling fast! Don't miss a once in a life time opportunity!
Back to top	IP Logged

ps47 God Member Offline Keeper of the 3Dfx Helppage Posts: 988 Slovakia,central Europe Gender:	Re: [S] - 3dfx Voodoo5 5500 AGP 4x Protoype Reply #2 - 26.07.13 at 23:29:16 no kidding. anyway, how safe is to use them in agp8x (1.5V) slots? I believe there was a topic about this somewhere, but I'm too tired to search.
Back to top	3Dfx Help Page / 3Dfx Game Guide IP Logged

RaverX

God Member

Offline

Voodoo2 fan

Posts: 533
Oradea, Romania
Gender: male

Re: [S] - 3dfx Voodoo5 5500 AGP 4x Protoype
Reply #3 - 28.07.13 at 23:55:30

ps47 wrote on 26.07.13 at 23:29:16:

no kidding. anyway, how safe is to use them in agp8x (1.5V) slots? I believe there was a topic about this somewhere, but I'm too tired to search.

I'm not 100% sure, but I think that even AGP 4X will damage the card. BTW AGP 8X is 0.8V. 1.5V is AGP 4X.

Anyway, as I said the connector will fit into AGP4X, but internally it needs 3.3V. So if you install it in a AGP4X mobo that can provide only 1.5V is a bad ideea, the setup "might" work for a few seconds/minutes, but it will most likely end up in smoke.

IP Logged

ps47 God Member Offline Keeper of the 3Dfx Helppage Posts: 988 Slovakia,central Europe Gender:	Re: [S] - 3dfx Voodoo5 5500 AGP 4x Protoype Reply #4 - 30.07.13 at 21:18:59 well, too bad - for some reason, I was under the impression that this would actually work. guess the Epox 8k3a+ will have to do then.
Back to top	3Dfx Help Page / 3Dfx Game Guide IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page