3dfx Archive - Lost Green VGA Signal Repair Voodoo 5 5500 PCI MAC

	Welcome, Guest. Please Login

Home

Help

3dfx Archive › 3dfx Section › Tech Talk › Lost Green VGA Signal Repair Voodoo 5 5500 PCI MAC

(Moderators: NitroX infinity, gdonovan, FalconFly)

‹ Previous Topic | Next Topic ›

Pages: 1

Lost Green VGA Signal Repair Voodoo 5 5500 PCI MAC (Read 287 times)

Great Hierophant

YaBB Newbies

Offline

I Love YaBB 2!

Posts: 3

Lost Green VGA Signal Repair Voodoo 5 5500 PCI MAC
07.10.08 at 22:39:57

I have a Voodoo 5 5500 MAC PCI that has a VGA port with a non-functioning (or extremely weak) green signal. Its DVI port outputs just fine, so I think it is likely that there is a fault somewhere in the green signal, such as a dead resistor or capacitator. Can anyone point me in the direction of instructions to isolate or fix the problem?

I have used two different monitors, one a TFT with a VGA/DVI-I cable, the second was a true CRT with its own cable. I have used some rubbing alcohol to clean the board, no change. The fans seem to work. I flashed the BIOS with a PC bios, but it appeared to work after that. [email][/email]

IP Logged

paulpsomiadis God Member Offline -=3Dfx still rox!=- Posts: 2011 Newcastle U.K. Gender:	Re: Lost Green VGA Signal Repair Voodoo 5 5500 PCI Reply #1 - 08.10.08 at 05:35:52 Chances are it will be DIRECTLY where the VGA socket is. I fixed an old GeForce card where the VGA port was actually SLACK!!! But if it's not, then try taking some hi-res photos of the card... Maybe we can play "spot the f***ed-up track"... ...worth a shot!
Back to top	-=To MOD or not to MOD, that is a DUMB question - just MOD it!=-&&&&+May God stand between you and harm in all the empty places you must walk.+ IP Logged

Great Hierophant YaBB Newbies Offline I Love YaBB 2! Posts: 3	Re: Lost Green VGA Signal Repair Voodoo 5 5500 PCI Reply #2 - 08.10.08 at 06:55:03 The only thing that is noticeably wrong is that the FL3 component, whatever that is, is missing the top half. It is the only component that comes in a three set. Maybe replacing it, if I figure out what it is, may work.
Back to top	IP Logged

paulpsomiadis

God Member

Offline

-=3Dfx still rox!=-

Posts: 2011
Newcastle U.K.
Gender: male

Re: Lost Green VGA Signal Repair Voodoo 5 5500 PCI
Reply #3 - 08.10.08 at 11:42:16

Yup this is most likely the cause of your problem. Undecided

The missing component is an SMT EMI Filter.
(since there are only THREE of them, we can assume they connect the R,G,B lines for your VGA socket - and your G line has one missing or damaged) Roll Eyes

I did a bit of Googling... Wink

Confirmed that label FL=Filter:

http://training.ipc.org/demos/pdf/drm18h.pdf
(page 10)

A replacement will be something like one of these...

http://www.syfer.com/Capacitors_1.aspx?id=1:27343&id2=1:27296

But as for the EXACT value and component size...you'll probably have to ask @Hank... Tongue

...if you can grab his attention. Huh

-=To MOD or not to MOD, that is a DUMB question - just MOD it!=-&&&&+May God stand between you and harm in all the empty places you must walk.+

IP Logged

Great Hierophant

YaBB Newbies

Offline

I Love YaBB 2!

Posts: 3

Re: Lost Green VGA Signal Repair Voodoo 5 5500 PCI
Reply #4 - 08.10.08 at 20:53:37

Thank you, I am much obliged. However, the Voodoo 5 5500 AGP board does not contain such filters anywhere on the board. (The Voodoo 5 5500 PCI PC version also contains them.) Perhaps they were designed to combat electrical interference coming from the PCI bus, which is shared with other devices. The AGP bus is not shared at all of course.

Quote:

But as for the EXACT value and component size...you'll probably have to ask @Hank... Tongue

...if you can grab his attention. Huh

Who is this veritable sage and how can I try to contact him?

« Last Edit: 08.10.08 at 21:00:02 by Great Hierophant »

IP Logged

OutOfRange

Senior Member

Offline

Posts: 348
Switzerland
Gender: male

Re: Lost Green VGA Signal Repair Voodoo 5 5500 PCI
Reply #5 - 11.10.08 at 22:30:43

In my opinion and cause you tell, the DVI is working properly there can be a problem with the RAMDAC itself, or somewhere on the "way" from the RAMDAC to the D-Sub connector.

Cause the DVI (sort of) reads the Picture directly out of the memory and the RAMDAC (Random Access Memory Digital Analog Converter) as it's called convert it, this might be the problem Huh

IP Logged

paulpsomiadis God Member Offline -=3Dfx still rox!=- Posts: 2011 Newcastle U.K. Gender:	Re: Lost Green VGA Signal Repair Voodoo 5 5500 PCI Reply #6 - 12.10.08 at 00:42:55 @Hank is an ex-3Dfx engineer who sometimes pops up on the forum...
Back to top	-=To MOD or not to MOD, that is a DUMB question - just MOD it!=-&&&&+May God stand between you and harm in all the empty places you must walk.+ IP Logged

voodooban_cn YaBB Newbies Offline I love 3dfx Posts: 33 shang hai, China Gender:	Re: Lost Green VGA Signal Repair Voodoo 5 5500 PCI MAC Reply #7 - 22.11.10 at 10:38:53 First check your D-SUB.and then you need to check the Lane of GREEN siginal,especially the low pass filter(inductor,capacitor and resistor) near the connector.I had refixed my VP560 once by change the inductor in LPF,the broken inductor made the Lane open.
Back to top	Opteron 250 X2/Tyan K8W /Infineon REG ECC DDR400 1G x3/Seagate 160GB+2 x WD 640GB/NMB 460W/Intel Tower/Nvidia 5950U/ECHO MIA MIDI/&&====================== IP Logged

exxe God Member Offline ^^ Posts: 1316 germany	Re: Lost Green VGA Signal Repair Voodoo 5 5500 PCI MAC Reply #8 - 22.11.10 at 12:40:06 maybe its the PACVGA chip
Back to top	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page